FloPlast Push Fit Waste Coupling - 32mm Grey - Pack of 5

In stock
Only %1 left
Code
WP07GPK5

Click or tap the image to open in fullscreen

FloPlast Push Fit Waste Coupling - 32mm Grey - Pack of 5
More Information
Code WP07GPK5
£8.90 £7.42 £1.49
Spend another £1500 to pay over time with Klarna

Waste couplings are used to join together two lengths of pipe. This type of system uses an O ring seal to make the joint.

This fitting is available in 32mm, 40mm and 50mm size options, with 50mm only available in grey.

This push fit waste system is manufactured in the UK to BS EN 1451 and is British Standard kitemarked.

When making a push fit joint, cut the pipe square and remove any burrs, push the pipe into the fitting as far as it will go and then withdraw it by approximately 10mm to allow for any expansion. The joint can be taken apart again if required, but always check that the O ring has not been dislodged from its housing groove in the fitting as this will cause the joint to leak.

If you do plan to take the joint apart once it has been made, we would suggest the use of SL40 spray lubricant to reduce the risk of friction and possible movement of the O ring.

Click here to read our guide that explains the key differences between push fit and solvent weld waste systems.

YOU MAY ALSO LIKE