FloPlast Round Downpipe Bend - 92.5 Degree x 68mm Brown

In stock
Code
RB1BR

Click or tap the image to open in fullscreen

FloPlast Round Downpipe Bend - 92.5 Degree x 68mm Brown
FloPlast Round Downpipe Bend - 92.5 Degree x 68mm Brown
More Information
Code RB1BR
£5.16 £4.30 £5.74 Save 10%
Spend another £1500 to pay over time with Klarna

92.5 Bends are used in a downpipe system to change the plane of the bend from vertical to horizontal or vice versa.

They are often used instead of offset bends when the soffit is particularly wide - this enables the pipe to run neatly below the soffit rather than dropping down diagonally back to the wall as it would with a normal swan neck setup.

The angle of the bend is 92.5 degrees rather than 90 degrees to encourage a slight fall, enabling rainwater to run away rather than sit in the pipe.

For a quick introduction to this fitting, please take a look at our PBSL Group video clip;

YOU MAY ALSO LIKE